P0036 HO2S Heater Control Circuit (Bank 1 Sensor 2)

Technical Description of OBD-II Trouble Code

Generic: HO2S Heater Control Circuit (Bank 1 Sensor 2)
GM: HO2S Heater Control Circuit Conditions

What does that signify?

This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles, including but not limited to Toyota, VW, Ford, Dodge, Honda, Chevrolet, Hyundai, Audi, Acura, etc. Specific repair steps may vary depending on the model.

Fuel injected vehicles use heated oxygen sensors in the exhaust system before and after the catalytic converters to determine oxygen content. This feedback is used to adjust the fuel system accordingly to maintain a proper air/fuel ratio of 14.7:1.

The oxygen sensors use a heated circuit to warm up the sensor for faster feedback operation. The oxygen sensor may use three or four wires depending on the vehicle, two are usually used for the sensor feedback to the Powertrain Control Module (PCM) / Engine Control Module (ECM) and the other wires are for the heater to power the heated circuit. Three wire sensors are usually grounded through the exhaust system, and four wire sensors have a separate ground wire.

The P0036 code refers to the sensor after the catalytic converter on bank 1, which is on the side of the engine with the #1 cylinder. The heater circuit may be supplied power or ground by the PCM/ECM or another source that can be controlled by the PCM/ECM.

Note: Be cautious not to work around an exhaust system that has been recently run as they can become very hot. This code is similar to P0030 and essentially identical to P0056.

Symptoms

Symptoms of a P0036 DTC include MIL (Malfunction indicator lamp) illumination. You will probably not notice any other symptoms associated with the failure of the heated circuit since it only runs momentarily when the vehicle is first started. This sensor is also after the catalytic converter, so it will not affect the air/fuel ratio input to the PCM/ECM; it is primarily used to verify the catalytic converter’s efficiency.

Causes

Potential causes of a P0036 trouble code may include:

Possible Solutions

Visually inspect the oxygen sensor wiring for damaged or loose wiring to the sensor.

Unplug the oxygen sensor and using a digital volt ohm meter (DVOM) set to the ohms scale, test the resistance of the heater circuit using a wiring diagram for reference. The heater circuit inside the sensor should have some resistance present, excessive resistance or an over limit reading would indicate an open in the heated portion of the circuit and the oxygen sensor will need to be replaced.

Back-probe the ground wire at the connector and check for resistance between a good known ground and the connector to the oxygen sensor.

Back-probe the power supply wire at the connector with the DVOM set to DC volts with the positive lead on the power supply wire and the negative lead at a good known ground to check for power to supply at the oxygen sensor. If no power is present at the connector during initial car startup (cold start), there may be a problem with the power supply circuit to the oxygen sensor or the PCM itself.

Related DTC Discussions

Register now to ask a question (free)

Need more help with a p0036 code?

If you still need help regarding the P0036 trouble code, please post your question in our FREE car repair forums.

Share

NOTE: This information is presented for information purposes only. It is not intended as repair advice and we are not responsible for any actions you take on any vehicle. All information on this site is copyright protected.

Professional Service

Of course we always recommend resolving this issue mechanically. However, if for some reason this seems impossible, then we have the option to permanently delete this specific DTC. We will continue to work on all other codes. If you want this, please upload your ECU file to our portal.